2. Pull the handle on the power supply assembly and pivot it downward as shown. Then, pull the entire
power supply assembly out of the chassis.
Figure 89. Removing the power supply assembly
3. Ensure that the new power supply assembly is the correct replacement.
4. Insert the new power supply assembly with the handle open into the chassis. Then, pivot the handle as
shown to fully install the new power supply assembly into position.
Note: You might need to push hard to close the handle if you feel resistance when you pivot the handle
to the closed position.
Figure 90. Installing the power supply assembly
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 133.
PCI card
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
106
ThinkStation P510 and P710 User Guide