Table of Contents
Advertisement
3.1.8 Removing the Center chassis (See Fig.19)
(1) Remove the 4 screws T attaching the Center chassis.
T
3.1.9 Removing the Main unit (See Fig.20)
(1) Remove the 4 screws U attaching the Main unit.
U
Fig.19
Fig.20
(No.WA022<Rev.001>)17/36
3.2
DVD mechanism
3.2.1 Removing the Traverse mechanism assembly (See
Fig.1 to 6)
(1) Solder the short land section on the flexible wire of pickup.
(See Fig.1)
Caution:
* Solder the short land section on the flexible wire of pickup
before disconnecting the flexible wire form the connector
T
CN101
on the Front end board.
If the flexible wire is disconnected without attaching the
solder, the pickup may be destroyed by static electricity.
* When attaching the Traverse mechanism assembly, re-
move the solder from the short land section after connection
the flexible wire to the connector
board.
U
(2) Voltage supply to
Clamper is shift to loading complete position. (See Fig.2)
(3) Disconnect the flexible wires from Traverse mechanism assembly
connected to connector
(See Fig.2)
CN1
CN101
on the Front end
Solder short part
Fig.1
TP79
and
TP81
approx DC 3.0V until
CN1
and
CN101
of the Front end board.
CN101
TP81
TP79 TP81
R312
TP92
R21
Voltage supply
TP79
position
Fig.2
Hide quick links:
Advertisement
Table of Contents
