Lamp; Lamp Replacement - Philips bClever SV1 User Manual

Lamp

MENU MENU OK OK
BRIGHTNESS
VOLUME +
VOLUME +
PICTURE FORMAT COLOUR TRACKING
DATA
KEY LOCK
PICTURE SIZE – PICTURE SIZE – PICTURE SIZE + PICTURE SIZE +
MENU
VOLUME – VOLUME –
DATA S-VIDEO VIDEO
STANDBY
SOURCE SOURCE AV MUTE

Lamp replacement

MENU MENU OK OK
VOLUME + VOLUME +
PICTURE SIZE – PICTURE SIZE – PICTURE SIZE + PICTURE SIZE +
VOLUME –
VOLUME –
DATA S-VIDEO VIDEO
STANDBY
SOURCE SOURCE AV MUTE
Philips Multimedia Projector
6. Maintenance
When operation time reaches the last 100 hours of the average lamplife, the message 'Warning:
lamplife has almost expired' will be displayed on the screen, each time the projector is switched
on.
The lamplife remaining can be checked using the OSD menu.
STAND BY
Press Menu.
1
PICTURE SIZE
CONTRAST FREEZE
– The menu bar appears on the screen.
ZOOM
S-VIDEO VIDEO
AV MUTE INFO
OK
KEYSTONE
MUTE
Use Cursor Control to select Lamp counter in the 'Set up' menu.
2
– The used lamplife hours are displayed.
– When the lamplife has expired the message 'Warning: lamplife has expired' is displayed on
the screen.
Switch off the projector and wait until the lamp has cooled down (about 5 minutes) before
1
disconnecting the projector. Remove the mains lead from both projector and wall socket.
The mains lead must be disconnected from the projector otherwise the lamp door
cannot be removed.
Turn the projector over. Never place the projector on the side where the connections are
2
located!
Remove the lamp door, using a screwdriver.
3
– When the lamp door is removed the mains inlet socket will be partly closed. The lamp door
therefore cannot be removed if the mains lead is not disconnected from the projector.
Read the caution and warning labels on the lamp holder.
4
32
English User guide bClever SV1
>