Motorola Cleartone CM5000 Basic Service Manual page 11

Product Safety and RF Exposure
• As with all fixed site antenna installations, it is the responsibility of the licensee to manage the
site in accordance with applicable regulatory requirements and may require additional
compliance actions such as site survey measurements, signage, and site access restrictions in
order to insure that exposure limits are not exceeded.
Electromagnetic Interference/Compatibility
Facilities
To avoid electromagnetic interference and/or compatibility conflicts, turn off your terminal in any
facility where posted notices instruct you to do so. Hospitals or health care facilities may be using
equipment that is sensitive to external RF energy.
Vehicles
To avoid possible interaction between the terminal transmitter and any vehicle electronic control
modules, such as, ABS, engine, or transmission controls, the terminal should be installed only by an
experienced installer and that the following precautions be used when installing the terminal:
1. Refer to the manufacturer's instructions or other technical bulletins for recommendations on
terminal installation.
2. Before installing the terminal, determine the location of the electronic control modules and their
harnesses in the vehicle.
3. Route all terminal wiring, including the antenna transmission line, as far away as possible from
the electronic control units and associated wiring.
Driver Safety
Check the laws and regulations on the use of terminals in the area where you drive. Always obey
them. When using your terminal while driving, please:
• Give full attention to driving and to the road.
• Pull off the road and park before making or answering a call if driving conditions so require.
CM5000 Mobile Repeater/Gateway - Basic Service Manual
Nearly every electronic device is susceptible to
electromagnetic interference (EMI) if inadequately shielded,
designed or otherwise configured for electromagnetic
compatibility. It may be necessary to conduct compatibility
testing to determine if any electronic equipment used in or
around vehicles or near fixed site antenna is sensitive to
external RF energy or if any procedures need to be followed to
eliminate or mitigate the potential for interaction between the
terminal transmitter and the equipment or device.
xi