Typical Test Setup - Motorola Cleartone CM5000 Basic Service Manual

TEST SETUP & ADJUSTMENT

Typical Test Setup

STEP 1
Set the DC power supply to 13.2 V. (More than 5 A current capacity DC power supply is required.)
STEP 2
Connect under adjustment radio terminal to DC power supply. (The radio terminal should be turned
off in this period.)
STEP 3
Connect the Antenna connector of radio terminal and RF connector of TETRA Tester of AEROFLEX
Type 2968.
STEP 4
Press Menu key and numeric key [2] and the Rotary knob simultaneously. The radio terminal
switches to JRC TEST mode.
CM5000 Mobile Repeater/Gateway - Basic Service Manual
Figure 11.
AEROFLEX TETRA
Tester
Model 2968
RF Cable
Radio Unit
TEST SETUP & ADJUSTMENT
Test Connection Diagram
DC Power supply
More than 5A current capacity
CHAPTER 4
13.2 V
27