Service Aids; Test Equipment - Motorola CDR500 Programming Manual

Foreword

Service Aids

Service Aids
The following table lists service aids recommended for working on the CDR500 Wall Mount Repeater and CDR700
Desktop Repeater.
Motorola Part No.
HLN9214
HSN9412
HKN9216
HKN9217
HVN9025
HVN9027

Test Equipment

The following table lists test equipment required to service the CDR500 Wall Mount Repeater and CDR700 Desktop
Repeater.
Motorola Model No.
R2200, R2400, or R2001
*R1049
*S1100
*S1053, *SKN6009,
*SKN6001
R1053
*S1350, *ST1215 (VHF)
*ST1223 (UHF) *T1013
S1339
*R1013
S1347 or
S1348 (prog)
xiv
Description
Radio Interface Box
RIB Power supply
Computer Interface cable
Program Test Cable
CDM-Series CPS
PRO-Series CPS
Description
Service Monitor This monitor will substi-
tute for items with an
asterisk *
Digital Multimeter
Audio Oscillator 67 to 200 Hz tones
AC Voltmeter, Power 1mV to 300V, 10-Megohm
Cable for meter, Test input impedance
leads for meter
Dual-trace Oscilloscope 20 MHz bandwidth,
5mV/cm - 20V/cm
50 Ohm, ±5% accuracy,
Wattmeter, Plug-in
Elements (VHF & UHF), 1-0 Watts, maximum
RF Dummy Load 0-1000 MHz, 300 Watts
RF Millivolt Meter 100uV to 3V RF, 10 kHz to
1.2 GHz
SINAD Meter
DC Power Supply 0-20 Vdc, 0-5 Amps
CDR500 & CDR700 Repeater Service Manual
Enables communication between the radio and the computer's
serial communications adapter.
Used to supply power to the RIB.
Connects the computer's serial communications adapter to the
RIB.
RIB to Radio Cable
Software on 3-1/2 in. diskettes.
Software on 3-1/2 in. diskettes.
Characteristics
Frequency/deviation meter and signal
generator for wide-range troubleshooting
and alignment
Two meters recommended for ac/dc volt-
age and current measurements
Used with service monitor for injection of
PL tones
Audio voltage measurements
Waveform measurements
Transmitter power output measurements
RF level measurements
Receiver sensitivity
Bench supply for 12.5 Vdc
6864110R66-O
Application
Application
March, 2001