Repackaging - Motorola CDR500 Programming Manual

CDR500 Wall Mount Repeater Station

Repackaging

4. If necessary, feed phone line(s) through the
vane grommet on the right side of the CDR500
repeater and connect to the repeater control-
ler(s).
5. If you are using a repeater controller with a
grounding wire, use the remaining lockwasher
and nut provided in Bag 2 to connect the wire to
the 1/4" threaded grounding stud on the inside
of the CDR500 repeater housing. If no ground-
ing wires are present, place the lockwasher and
nut on the threaded
2.25 to 3.38 N-m (20 to 30 in.-lbs.) torque.
IMPORTANT
Before connecting the AC line cord into
an AC mains outlet, ensure that the "115/
230" V ac switch on the power supply is
in the appropriate position. The switch is
located on the power supply housing
near the fan.
6. Connect the ac line cord to the CDR500
repeater, attach the retaining cable clamp and
plug the other end of the cord into the AC
main outlet.
CAUTION
A retaining cable clamp for the AC
power cord is provided with your
CDR500 repeater to keep the power cord
plug in the connector.
To prevent accidental disconnection of
the power cord, plug it into the CDR500
repeater and attach the retaining cable
clamp to the CDR500 repeater housing
with the center top mounting screw of
the power supply before connecting the
cord to an AC power source (refer to
Figure 2-6).
7. If you are using a battery backup, refer to sec-
tion Section 7 for further information. Other-
wise install the battery connector shroud.
Refer to Figure 2-6.
2-8
stud. Tighten to
Repackaging
The CDR500 Repeater Station's shipping box is recom-
mended for reshipping. If it is necessary to repackage
the repeater as a built-up unit, follow these suggested
steps to repackage the unit in its original box.
6864110R66-O
CDR500 & CDR700 Repeater Service Manual
Retaining
Clip Screw
Figure 2-6. Placement of Battery Connector Shroud
CAUTION
The CDR500 repeater shipping box may
be used for reshipping a built-up unit.
Please ship with extreme care.
CAUTION
Motorola, Inc. takes no responsibility for
reshipping a built-up CDR500 repeater.
CAUTION
Extreme caution should be taken when
reshipping an CDR500 repeater in its
o r i g i n a l b o x . A b u i l t - u p C D R 5 0 0
repeater could weigh approximately a
maximum of 60 pounds (27.2 kg) when
fully assembled and in its original box.
Lifting improperly can cause injury. Get
help from a second person and use care
when lifting the repeater.
Vane
Grommet
Grounding
Stud
Battery
Connector
Shroud
Two conductor
Barrier Strip
March, 2001