Mitsubishi Electric GOT2000 Series User Manual page 133

■2. GT2512F-S, GT2510F-V, GT2508F-V
Open an installation hole on the control panel with the dimensions as shown below.
D
Fitting
installation
Model position
(on the
GOT)
Long side
of the GOT
GT2512F-S
Short side
of the GOT
Long side
of the GOT
GT2510F-V
Short side
of the GOT
Long side
of the GOT
GT2508F-V
Short side
of the GOT
The C to F dimensions show the measurements for installing fittings on the control panel.
Additionally, install studs on the control panel.
For information on how to install studs, refer to the following.
➠ 6.3 Stud
Horizontal
A
Back of the control panel
A B
269(10.59) 214(8.43)
(+2(0.08), 0(0)) (+2(0.08), 0(0))
234(9.21) 187(7.36)
(+2(0.08), 0(0)) (+2(0.08), 0(0))
194(7.64) 158(6.22)
(+2(0.08), 0(0)) (+2(0.08), 0(0))
Vertical
E
F
Back of the control panel
C D
28(1.10) 17(0.67) 36(1.42)
10(0.39) 35(1.38) 18(0.71)
28(1.10) 33(1.30) 32(1.26)
10(0.39) 51(2.01) 14(0.55)
28(1.10) 14(0.55) 32(1.26)
10(0.39) 32(1.26) 14(0.55)
6.2 Panel Cut Dimensions
B
C
Unit: mm (inch)
Panel
E F
thickness
26(1.02)
44(1.73)
33(1.30)
1.5(0.06)to
4(0.16)
51(2.01)
29(1.14)
47(1.85)
6 - 5
6