NEC 424 Installation Manual page 13

Mounting by commercially available screws
IMPORTANT
• Before mounting the touch module by commercially available screws, make sure the ad-
justment of the touch module (hereinafter described) can be performed properly. Please
consider temporally mount until proper performance of adjustment can be checked. Take
preventive measure from falling down for the temporally mount, too.
• Utilize the magnet set holes for mounting the touch module by screws.
Remove the magnets from the touch module by a plus headed Phillips driver. Keep the removed
magnets and screws.
• Mount the touch module onto a screen or a white board by commercially available screws.
Reference
• For using the table projection mount unit, secure the touch
module by a commercially available double sided adhesive
tape sealed on the rear face of the touch module.
Prepare the double sided adhesive tape of which thick-
ness is in the range from 1.2 mm to 1.5 mm.
CAUTION
• Do not use a double sided adhesive tape besides for mounting the touch module on a
table. It may cause of injury by fallen down touch module.
ENG-11