Declaration Of Conformity - NEC 424 Installation Manual

page of 176

/ 176
Contents
Table of Contents
Bookmarks

Table of Contents

Available languages

DOC Compliance Notice (for Canada only)

This Class B digital apparatus complies with Canadian ICES-003.

RF Interference (for USA only)

WARNING

The Federal Communications Commission does not allow any modifications or changes to the

unit EXCEPT those specified by NEC Display Solutions of America, Inc. in this manual. Failure

to comply with this government regulation could void your right to operate this equipment. This

equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio / TV technician for help.

WARNING TO CALIFORNIA RESIDENTS:

Handling the cables supplied with this product will expose you to lead, a chemical known to

the State of California to cause birth defects or other reproductive harm. WASH HANDS AFTER

HANDLING.

This device complies with Part 15 of FCC Rules. Operation is subject to the following two

conditions. (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

U.S.Responsible Party:

Address:

Tel. No.:

Type of Product:

Equipment Classification:

Model No.:

We hereby declare that the equipment specified above conforms to the technical

standards as specified in the FCC Rules.