Brother HL-1050 Technical Reference Manual page 306

Select international character set
EscRn (27)(82)n
 This command selects one of the available international character sets, refer to the printer User Guide for
supported character sets.
 Each character set varies slightly from the others and contains a small number of special characters necessary
for printing in that particular language.
 The selection you make with this command does not affect any italic or graphics character table selection that
you may have made with the Esc t command.
 The character sets listed below, plus several others, can also be selected from the printer's control panel.
 The character sets available and the corresponding values of n are as follows:
US ASCII
French I
German
UK ASCII I
Danish I
Swedish
Italy
Spanish
 If you have selected the graphics character table with the Esc t 1 command the following additional character
sets are available.
LPRINT CHR$(27); CHR$(82); CHR$(3); 'Select British char set
Select italic / graphics character table
Esctn (27)(116)n
 This command allows you to choose between two character tables - the italic character table and the graphics
character table.
 The two tables are shown in the Epson FX-850 section of the appendix at the end of this manual.
 Set n to 0 to select the italic character table. Character codes in the range 160 to 255 are now italic
characters.
 Set n to 1 to select the extended character table. Character codes in the range 128 to 255 are now foreign
language and graphics characters.
 You can still print italic characters using the Select Italic Mode, Esc 4, command even when you have
selected the graphics character table.
<1Bh><52h>n
0 Japanese
1 Norwegian
2 Danish II
3 UK ASCII II
4 French II
5 Dutch
6 South African
7
Norwegian set I
Norwegian set II
<1Bh><74h>n
CHAPTER 6 EPSON - 22
8
9
10
13
14
15
16
17 IBM set I
18 IBM set II
19
20