Copper Ethernet Ports - Siemens RUGGEDCOM RX1501 Installation Manual

Chapter 3
Communication Ports
Section 3.1

Copper Ethernet Ports

The RX1501 supports several 10/100Base-TX Ethernet ports with RJ45 or M12 (bypass or non-bypass)
connectors. The RJ45 and M12 connectors are directly connected to the chassis ground on the device and can
accept CAT-5 shielded twisted-pair (STP) cables.
CAUTION!
Contamination hazard – risk of damage to equipment. M12 modules are shipped with internal O-rings
and dust caps to prevent the ingress of dirt and debris that may damage the port. Make sure the O-
rings and dust caps are installed on all unused M12 ports.
Figure 15: 2 × 10/100/1000TX with RJ45 Ports
Figure 17: 2 x 8-Pin 10/100/1000TX with M12 A-Coded
Ports
Figure 19: 2 x 8-Pin 10/100/1000TX with M12 X-Coded
Ports
Figure 21: 4 x 8-Pin 10/100TX with M12 A-Coded Ports
18
Figure 16: 6 × 10/100TX with RJ45 Ports
Figure 18: 2 x 8-Pin 10/100/1000TX with M12 A-Coded
Bypass Ports
Figure 20: 2 x 8-Pin 10/100/1000TX with M12 X-Coded
Bypass Ports
Figure 22: 4 x 8-Pin 10/100TX with M12 A-Coded
Bypass and Non-Bypass Ports
RUGGEDCOM RX1501
Installation Guide
Copper Ethernet Ports