Ruggedcom Ape Module - Siemens RUGGEDCOM RX1501 Installation Manual

RUGGEDCOM RX1501
Installation Guide
The module is compatible with the following standards:
• AT&T PUB 62310 (Standard DDS)
• BELLCORE TA-TSY-000077
• BELLCORE TR-TSY-000458
• ANSI T1.410
It also supports the following operating modes:
Operating Mode
DDS-PRI
CC-64K
Each RJ45 port features a RX and TX LED that indicates the state of the port.
LED
Rx
Tx
Rx
Tx
Rx
Tx
Rx
Tx
The following is the pin-out for the DDS RJ45 ports:
8
Figure 48: DDS RJ45 Pin
Section 3.8

RUGGEDCOM APE Module

The RX1501 supports various versions of the RUGGEDCOM APE (Application Processing Engine) module. The
APE is an x86-based computer design that can host a variety of x86-based operating systems. It also features
RUGGEDCOM APE Module
LED Color Status
Green Frame sync detected and signal OK.
The interface is enabled and remote device has no errors.
Yellow Signal OK, but no frame sync.
The interface is in loopback mode.
Red Loss of signal.
Loss of signal or receiving any of OOS, UNM, or UMC codes: the remote device is
out of service or has problems with the signal.
Off The interface is not enabled.
The interface is not enabled.
1
Line Rate
56 kbps
72 kbps
Pin
1
2
3
4
5
6
7
8 Receive data from network (Ring)
Communication Ports
Description
Transmit data to network (Tip)
Transmit data to network (Ring)
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Receive data from network (Tip)
Chapter 3
31