X521 Sensor Connection 2 Htl/Ttl Without Open-Circuit Monitoring; X531 Sensor Connection 2 Htl/Ttl Without Open-Circuit Monitoring - Siemens SINAMICS S120 Equipment Manual

4.5.3.4

X521 sensor connection 2 HTL/TTL without open-circuit monitoring

Table 4-17 Sensor connection X521
Pin
1
2
3
4
5
6
7
8
Max. connectable cross-section: 1.5 mm
When unipolar HTL sensors are used, terminal block A*, B*, and R* must be jumpered with M.
4.5.3.5

X531 sensor connection 2 HTL/TTL without open-circuit monitoring

Table 4-18 Sensor connection X531
Pin
1
2
3
4
5
6
7
8
Max. connectable cross-section: 1.5 mm
Note
Ensure that when the sensor is connected via terminals, the cable shield must be placed on
the module.
Shield brackets for the SMC30 are available from:
Weidmüller: http://www.weidmueller.com
Equipment Manual Control Units and Additional System Components
Equipment Manual, (GH1), 12/2004 Edition, 6SL3097-2AH00-0BP1
Name
A
A*
B
B*
R
R*
CTRL
M
2
Name
P_Encoder 5 V / 24 V
M_Encoder
-Temp
+Temp
Reserved, do not use
Reserved, do not use
Reserved, do not use
Reserved, do not use
2
4.5 Sensor Module Cabinet 30 (SMC30)
Technical specifications
Incremental signal A
Inverted incremental signal A
Incremental signal B
Inverted incremental signal B
Reference signal R
Reference signal R*
Control signal
Ground via inductivity
Technical specifications
Sensor power supply
Ground for sensor power supply
Motor temperature measurement KTY84-1C130
Temperature sensor connection KTY84-1C130/PTC
Encoder System Connection
4-25