Alarm Information - GE AF-300 P11 User Manual

4.3.11 Alarm Information

Select 7. Alarm Information (ALM INF) on the Program Menu screen. A variety of operating data at the time the latest
alarm occurred is displayed. Use UP and DOWN to switch between the nine screens of alarm information data.
60.00
RUN
FWD
PRG
PRG > PRG MENU
F/D > LED SHIFT
OC1
TIME=xxxxxh
Cumulative operating hours at alarm occurence
EDC=xxxV
DC link circuit voltage at alarm occurence
TMPI=xxxx°C
Temperature inside drive at alarm occurence
TMPF=xxxx°C
Heat sink temperature at alarm occurence
Input terminal status at a alarm
OC1
occurence (terminals)
REM X2 X6
FWD X3 X7
REV X4 X8
X1 X5 X9
Output terminal status at a alarm
occurence
OC1
SIGNAL OFF, SIGNAL ON
Y1 Y5
Y2
Y3
Y4
OC1
Multiple alarms
5=xxx
(Simultaneously
4=xxx
occuring alarms)
3=xxx
2=xxx
Alarm code
Up to four alarm codes can be dosplayed simultaneously.
Data subject to change without notice 7/07. © 2007 GE Drives
60.00
1.DATA SETTING
FUNC
DATA
2.DATA CHECK
3. OPR MNTR
4. I/O CHECK
5. MAINTENANCE
6. LOAD FCTR
> 7. ALM INF
SIGNAL OFF, SIGNAL ON
Previous alarm
Before previous alarm
Two times before previous
Code of latest alarm
(High speed blinking during alarm
OC1
mode only)
Output frequency at alarm
Fout=xxxx.xHz
Output current at alarm occurence
Iout=x.xxA
Output voltage at alarm occurence
Vout=xxxV
Torque calculation value at alarm
TRQ=xxx%
occurence
OC1
Fref=xxxx.xHz
xxx xx xx xx
OC1
NRK=xxxxx
NRR=xxxxx
NRO=xxxxx
OC1
Input terminal status at a alarm
occurence (communication)
COM X2 X6
SIGNAL OFF, SIGNAL ON
FWD X3 X7
REV X4 X8
X1 X5 X9
OC1
Lastest alarm
0/1 =xxx xxx No. of occurences
-1 =xxx xxx
Alarm history
-2 =xxx xxx
No. of occurences
-3 =xxx xxx
Updated at alarm occurence. If the
cause of an alarm is the same as the
previous one, only the number og
occurences is incremented.
4-11
Setting frequency at alarm occurence
Operating status at alarm occurence
FWD/REV: Rotating
IL: Current limiting
VL: Voltage limiting
LU: Under voltage
TL: Torque limiting
No. of communication errors at
alarm occurence: Keypad panel
No. of communication errors at
alarm occurence: RS 485
No. of communication errors at
alarm occurence: Options