HP 3300A Technical Manual page 8

AVAILABLE PLUG-IN UNITS:
Model 3301A Auxiliary Plug-In.
Model 3302A Trigger Plug-In.
Model 3304A Sweep/Offset Plug-In.
Model 3305A Sweep Plug-In.
OUTPUT WAVEFORMS: Sinusoidal, square, and
triangle selected by panel switch. (Any two
outputs available simultaneously.
FREQUENCY RANGE: 0.01 Hz to 100 kHz in
seven decade ranges.
FREQUENCY RESPONSE: ± 1%, 0.01 Hz to 10
kHz; ± 3%, 10 kHz to 100 kHz on the X10K
range.
DIAL ACCURACY:. ± 1% of maximum dial setting
(1 minor division) 0. 01 Hz to 10 kHz; ±2% of
maximum dial setting (2 minor divisions) 10
kHz to 100 kHz. T. C. 0. 1%/°C.
MAXIMUM OUTPUT PER CHANNEL: > 35 volts
peak-to-peak open circuit; > 15 volts peak-to-
peak into 600 ohms; > 2 volts peak-to-peak into
50 ohms.
OUTPUT ATTENUATORS (both channels): 40 dB
range.
OUTPUT IMPEDANCE: 600 ohms nominal (both
channels) ± 20%.
Figure 1-1. Model 3300A Function Generator
Table 1-1. Specifications
1-0
SINE WAVE DISTORTION: <1%. 0.01 Hz to 10
kHz; <3%, 10 kHz to 100kHz on the X10K range.
SQUARE WAVE RESPONSE: <250 nsec rise and
fall time on all ranges; <500 nsec rise and fall
time in -A; <1% sag; <5% overshoot at full out-
put; <1% symmetry error.
TRIANGLE LINEARITY: <1% 0.01 Hz to 10 kHz;
<2%, 10 kHz to 100 kHz at full output; < 1%
symmetry error.
SYNC PULSE OUTPUT: > 10 volts peak-to-peak
open circuit, <5 µsec duration. Sync pulse
occurs at crest of sine and triangle wave.
DC STABILITY: Drift: <±0.25%6 of peak-to-peak
amplitude over a period of 24 hours. (After 30
minute warmup).
REMOTE FREQUENCY CONTROL: 0 to -10 volts
will linearly change frequency > 1 decade with-
in a single range. Frequency resetability with
respect to voltage ±1% of maximum frequency
on range selected.
POWER: 115 or 230 volts ±10%, 48 to 440 Hz.
Less than 50 watts.
DIMENSIONS: (inches and millimeters) 5" high
(127 mm), 16" wide (406 mm), 11" deep
(279 mm).
TM 11-6625-2494-14&P