Riser Card - Philips MCP9360i Service Manual

12.5.

Riser Card

12.5.1. Riser Card Subassembly Removal
1. Remove the top cover. See paragraph 12.1.1.
2. Remove the 2 mounting screws (1) from the riser card subassembly. See Figure 12.5-1.
3. Push the locking tab arm (3) on the motherboard PCI-E connector to release the PCI-E riser card. See Figure 12.5-2.
4. Pull upwards on the riser card bracket (4) until the riser cards are free from the motherboard connectors. See Figure 12.5-2.
5. Disconnect the SCART cable (5) from the ADD2 Graphics card. See Figure 12.5-3.
1
12.5.2. Riser Card Re-Assembly
To re-assemble the riser card subassembly, do all steps described in paragraph 12.5.1 in reverse order.
Note: The torque setting required for the riser card subassembly mounting screws (1) is 8 kg-cm.
1
Figure 12.5-1
5
Figure 12.5-3
Hardware Repair
3
MCP9360i 12.
4
2
Figure 12.5-2
EN 43