Philips MCP9360i Service Manual page 44

EN 44 12.
12.6. ADD2 Graphics Card
12.6.1. ADD2 Graphics Card Removal
1. Remove the top cover. See paragraph 12.1.1.
2. Remove the riser card subassembly. See paragraph 12.5.1.
3. Remove the 4 mounting screws (1) from the riser card subassembly backplate. See Figure 12.6-1.
4. Remove the 2 screws (2) from the DVI connector. See Figure 12.6-2.
5. Remove the 2 mounting screws (3) from the PCI-E riser card. See Figure 12.6-3.
6. Remove the mounting screw (4) from the ADD2 Graphics card. See Figure 12.6-3.
7. Remove together the ADD2 Graphics card and the PCI-E riser card from the riser bracket.
8. Push the locking tab arm (5) on the PCI-E connector to release the ADD2 Graphics card. See Figure 12.6-4.
9. Pull the ADD2 Graphics card free from the PCI-E riser card connector.
1
3
12.6.2. ADD2 Graphics Card Re-Assembly
To re-assemble the ADD2 Graphics card, do all steps described in paragraph 12.6.1 in reverse order.
Note: The torque setting required for the ADD2 Graphics card mounting screw (4) is 6 kg-cm.
The torque setting required for the PCI-E riser card mounting screws (3) is 6 kg-cm.
The torque setting required for the DVI connector screws (2) is 6 kg-cm.
The torque setting required for the riser card backplate mounting screws (1) is 8 kg-cm.
MCP9360i Hardware Repair
1
1
1
Figure 12.6-1
3
Figure 12.6-3
5
4
2
2
Figure 12.6-2
Figure 12.6-4