Philips MCP9360i Service Manual page 49

12.10. Card Reader
12.10.1. Card Reader Subassembly Removal
1. Remove the top cover. See paragraph 12.1.1.
2. Remove the main bezel. See paragraph 12.2.1.
3. Remove the HDD subassembly. See paragraph 12.3.1.
4. Disconnect the cable (1) from the rear of the card reader board. See Figure 0-1.
5. Remove the mounting screw (2) from the card reader subassembly. See Figure 0-2.
6. Slide the card reader subassembly out from the chassis and remove it.
12.10.2. Card Reader Subassembly Re-Assembly
To re-assemble the card reader subassembly, do all steps described in paragraph 12.10.1 in reverse order.
Note: The torque setting required for the card reader subassembly mounting screw (2) is 6 kg-cm.
12.10.3. Card Reader Board Removal
1. Remove the card reader subassembly. See paragraph 12.10.1.
2. Remove the 3 mounting screws (3) from the card reader board. See Figure 0-3.
3. Remove the card reader board from the card reader cage.
12.10.4. Card Reader Board Re-Assembly
To re-assemble the card reader board, do all steps described in paragraph 12.10.3 in reverse order.
Note: The torque setting required for the card reader board mounting screws (3) is 6 kg-cm.
1
Figure 0-1
3
3
3
Figure 0-3
Hardware Repair MCP9360i 12.
2
Figure 0-2
EN 49