Philips MCP9350i Service Manual page 31

11.23. Graphics Card and Video Output Connectors
11.23.1. Required Equipment
•
TV and/or Monitor with the following inputs:
•
SCART
•
DVI
•
VGA
•
S-Video
•
Cables for each of these inputs
11.23.2. Test Procedure
1. Connect the TV and/or monitor to the four video outputs of the Media Center.
2. On the MediaCenter: select the ' Intel® Graphics Media Accelerator Driver ' icon in the icon bar on the bottom right.
3. Select the graphics properties option.
4. Select the ' Intel® Dual Display Clone ' option and make sure that the primary device is ' digital display ' and the secondary device
is ' television '.
5. Switch you monitor and/or TV between the different inputs to check if the desktop can be seen on all four (Scart, DVI, VGA and S-
Video) output modes.
6. Return the set to the original settings.
11.23.3. Fail Procedure
For the SCART output:
Replace the ADD2_SCART cable.
-
- Replace SCART connector board. See paragraph 12.16.3.
Replace PCI-express riser board. See paragraph 12.6.
-
Replace graphics card. See paragraph 12.6.
-
- Replace the motherboard. See paragraph 12.16.9.
For the DVI, VGA or S-Video outputs:
- Replace PCI-express riser board. See paragraph 12.6.
Replace graphics card. See paragraph 12.6.
-
- Replace the motherboard. See paragraph 12.16.9.
Hardware Tests MCP9350i 11. EN 31