Philips MCP9350i Service Manual page 49

12.9.4. RJ11 Connector Subassembly Re-Assembly
To re-assemble the RJ11 connector subassembly, do all processes described in paragraph 12.9.3 in reverse order.
Note: The torque setting required for the RJ11 connector subassembly mounting screws (6) is 8kg-cm
12.9.5. RJ11 Board Replacement
1. Remove the RJ11 connector subassembly. See paragraph 12.9.3.
2. Remove the 2 mounting screws (7) from the RJ11 board. See Figure 12.9-4.
3. Remove the RJ11 board from the RJ11 cage.
12.9.6. RJ11 Board Re-Assembly
To re-assemble the RJ11 board, do all processes described in paragraph 12.9.5 in reverse order.
Note: The torque setting required for the RJ11 board mounting screws (7) is 6kg-cm.
7
7
Figure 12.9-4
Hardware Repair MCP9350i 12. EN 49