Hitachi HT-4139-28 Troubleshooting Manual page 45

Troubleshooting
Table 2.2 Error Code (Host)
Code Detail Cause
90G00201 - An argument check error has occurred.
01050001 Specification image type error
01050002 Four-point-coordinates acquisition flag
error
01050004 Scanning mode flag check error
01070001 Specification image type error
01070002 Sheet double-check execution flag error
01070003 Sheet check execution flag error (Length)
01070004 Mixed sheet length error
01070005 Sheet check execution flag error
(Minimum length)
01070006 Sheet check execution flag error (Width)
01070007 Mixed sheet width error
01070008 Sheet check execution flag error
(Minimum width)
01070009 Sheet check execution flag error (Skew)
0107000A Paper skew angle error (Left limit angle)
0107000B Paper skew angle error (Right limit angle)
0107000
Scanning mode flag check error
C
01100001 Device connection check flag error
2-34
(23/29)
Recovery
-
Check image setting again
If not recovered, get dump
information (refer to 1.4) and
contact Hitachi.
Check sheet check setting
again
Refer to Appendix of this
manual: A-4 Notes for sheet
check.
If not recovered, get dump
information (refer to 1.4) and
contact Hitachi.
Check connection of device.
If not recovered, get dump
information (refer to 1.4) and
contact Hitachi.