R Commands
record netflow ipv6
To select a NetFlow IPv6 record for the NetFlow monitor, use the record netflow ipv6 command. To
remove the record selection, use the no form of this command.
Syntax Description
original-input
original-
output
protocol-port
Defaults
None
Command Modes
NetFlow monitor configuration (config-flow-monitor)
Supported User Roles
network-admin
vdc-admin
Command History
Release
4.1(3)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to select a NetFlow IPv6 record for the NetFlow monitor:
switch(config)# flow monitor Custom-NetFlow-Record-1
switch(config-flow-monitor)# record netflow ipv6 original-input
This example shows how to remove the NetFlow IPv6 record selection:
switch(config-flow-monitor)# no record netflow ipv6 original-input
switch(config-flow-monitor)#
Related Commands
Command
show flow sw-monitor
OL-25806-03
record netflow ipv6 {original-input | original-output | protocol-port}
no record netflow ipv6 {original-input | original-output | protocol-port}
Specifies the traditional IPv6 input NetFlow.
Specifies the traditional IPv6 output NetFlow.
Specifies the protocol and ports aggregation scheme.
Modification
This command was introduced.
Description
Displays information about NetFlow monitors.
Cisco Nexus 7000 Series NX-OS System Management Command Reference
record netflow ipv6
351