Mounting The Device; Flush Panel Mounting; Figure 212: Location Of Battery Isolation Strip - GE MiCOM P40 Agile Technical Manual

Feeder management ied

Hide thumbs Also See for MiCOM P40 Agile:

Table of Contents

MOUNTING THE DEVICE

The products are dispatched either individually or as part of a panel or rack assembly.

Individual products are normally supplied with an outline diagram showing the dimensions for panel cut-outs and

hole centres.

The products are designed so the fixing holes in the mounting flanges are only accessible when the access covers

If you use a P991 or MMLG test block with the product, when viewed from the front, position the test block on the

right-hand side of the associated product. This minimises the wiring between the product and test block, and

allows the correct test block to be easily identified during commissioning and maintenance tests.

If you need to test the product for correct operation during installation, open the lower access cover, hold the

battery in place and pull the red tab to remove the battery isolation strip.

Panel-mounted devices are flush mounted into panels using M4 SEMS Taptite self-tapping screws with captive

3 mm thick washers (also known as a SEMS unit).

Do not use conventional self-tapping screws, because they have larger heads and could

damage the faceplate.

Alternatively, you can use tapped holes if the panel has a minimum thickness of 2.5 mm.

For applications where the product needs to be semi-projection or projection mounted, a range of collars are

If several products are mounted in a single cut-out in the panel, mechanically group them horizontally or vertically

into rigid assemblies before mounting in the panel.

P14xEd1-TM-EN-1

Chapter 20 - Installation