Caller Id; Program 14-02-10, Program 15-03-09; Configuration Sheet: Caller Id - NEC SL2100 Getting Started Manual

SL2100 GETTING STARTED GUIDE
Give each exchange line the access properties for the TAM number.
PRG 14-07-01
TAM Trunk 1
Number
1
7
2
0
3
0
4
0
5
0
Although there are 128 TAM numbers available, only five are listed as this is normally sufficient.

2.11 Caller ID

You will need to enable this setting if:
You have Caller ID service supplied on your outside lines.
You have Analog telephones that are Caller ID compatible.
The SL2100 can detect the Caller ID and display it on the LCD display of the SL2100 system phones.
It can also be available at a Analog phone that is Caller ID compatible.
You will need turn on the Caller ID detection for each trunk where it will be received. You will also need to turn on
Caller ID for each of the analog telephones that are Caller ID compatible.

2.11.1 Program 14-02-10, Program 15-03-09

Turn on Caller ID for each Analog trunk.
2.11.1.1 Default Setting
The default for Caller ID is 1 (on for each trunk).
No. Operation
1 Log into Programming Mode.
If you have already logged into Programming Mode, skip this
operation.
2 Dial 14 02 10. For each trunk, enter 1 to turn on Caller ID. You can
overwrite the current entry and press Hold key to confirm the entry
and step to the next option.
3 When you are done, press Mute key several times to return to
Programming Mode.
Dial 15 03 09. For each telephone, enter 1 to turn on Caller ID. You
4
can overwrite the current entry and press Hold key to confirm the
entry and step to the next telephone.
5 When you are done, press Mute key several times to return to
Programming Mode.
6 Press Speaker key to save changes and exit if you are finished.

2.11.2 Configuration sheet: Caller ID

With defaults shown.
Turn on the Caller ID for each trunk.
62
Trunk 2 Trunk 3
7 7
0 0
0 0
0 0
0 0
Values available:
0 – No access
Trunk 4
1 – Outgoing only
2 – Incoming only
7
3 – Retrieve held call only
0
4 – Outgoing and retrieve held call
5 – Incoming and retrieve held call
0
6 – Incoming and outgoing
0
7 – Incoming, outgoing and retrieve held call
0
Display Shows;
_________________________
______Program
_Base_Service_OP1__OP2__
14-02-10
Caller ID
15-03-09
Ext No Display
Mode_______
Trunk1
0:No
← - + →
TEL101
0:Off
← - + →