Bosch HEI7052U Installation Instruction page 13

red
white
black
Figure 12: Four Wire Range Cord Connection (continued)
Three Wire Range Cord Connection
9. Tighten all connections securely and replace terminal block cover.
10. Properly secure strain relief (see previous section).
Note: DO NOT plug in range at this time.
The Four Wire Connection (above) is preferred, but where local codes and ordi-
nances permit grounding through neutral and where conversion to four wire is
impractical, the unit may be connected to the power supply via a three wire con-
nection.
1. Disconnect electrical power at breaker box.
2. Remove the terminal block cover to expose the terminal block.
Figure 13: Terminal Block
3. Remove top nut, star washer, and round washer from each post.
Note: DO NOT remove last round washer, last nut or internal wiring leads.
4. Attach white wire, round washer, star washer and nut IN THIS ORDER on top
of ground strap on center post.
5. Attach red wire, round washer, star washer and nut IN THIS ORDER to left
post.
English 11