Installation Procedure - Bosch HEI7052U Installation Instruction

1. Adjust height of range and level by rotating the adjustable leg supports on the
bottom of the range, using 1-1/4" wrench.
2. Measure to locate bracket position as shown in See Figure 5: Anti-Tip
Bracket.
3. Secure bracket with 2 screws adequate for mounting surface (i.e., for wood
floor use wood screws, for concrete floor use concrete anchors and screws).
rearwall
cabinet wall
anti-tippin g
device
flush against
cabinet wall
Figure 5: Anti-Tip Bracket
Ventilation Recommendations
We strongly recommend the installation of a ventilation hood above this appli-
ance. For most kitchens a certified hood rating of not less than 300 CFM is recom-
mended. The range hood must be installed according to instructions furnished
with the hood.
Installation Procedure
Apply Foam Tape
Install Backwall Trim
(Optional)
Apply foam tape to underside of cooktop trim in one continuous piece.
Note: DO NOT use caulk or glue/adhesive of any kind.
Note: This step is only required if the countertop does not connect behind the
range (i.e.; when replacing a free-standing range). If backwall trim and attach=
ment screws are required, they may be ordered from the service center by calling
800-944-2904 at no charge for up to one year after purchase date of your Slide-
In Range. When ordering, refer to Service Backwall Trim Kit part no. 652010.
See "Cabinet Requirements" on page 6 for more information.
English 7