Philips VARI-LITE VL6000 Beam Luminaire User Manual page 43

WARNING: Ensure that the bracket locking mechanism is fully seated after the bracket is installed
on the luminaire. AVERTISSEMENT: Assurez-vous que le mécanisme de support de verrouillage est
complètement inséré après le support est installé sur l'appareil.
Bracket
Orientation
Brackets
Example Bracket
Orientations
Installing in Truss:
Step 1. Using two people, lift luminaire into mounting position.
Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g.
wing bolt) is properly tightened and that luminaire is fully supported.
Step 3. Attach safety cable (as required) as follows (refer to
a. Loop safety cable at least once around safety cable anchor point rod.
b. Loop safety cable at least once around truss/pipe and secure around pipe.
02.97 08.000 2
Example Truss Hook and Mounting Hardware (not included, sold separately)
Mount Bracket*
Raised Mounting Buttons (8 each)
Fit bracket's keyed hole and locking mechanism
over raised mounting buttons and slide forward
to lock.
Locking
Mechanism
Keyed Hole
Figure 2-9: Installing Brackets on Luminaire Enclosure
2 7 Ap ril 2 017
I : I
NSTALLATION NSTALLATION
Mount
Bracket
Figure 2-10
P
ROCEDURES
Locking
Mechanism
Locked
Press up to
install or release
on page 26):
2
25