Table of Contents
Advertisement
Self Tests
Running Parameter Tests
The luminaire is capable of running self tests by using the TEST menu functions. For complete details
and values for each test refer to
When running tests on multiple luminaires, a DMX termination connector is required at the last
luminaire in the link. (Refer to
connector.).
AC In
Data In
Master luminaire containing
software version to download
To run tests:
Step 1. Press [ESC].
Step 2. Press [Up] / [Down] arrows until Test appears. Press [OK].
Step 3. Use [Up] / [Down] arrows to select a parameter to test. Refer to
on page 59
Step 4. Press [OK] to run test.
Step 5. Press [ESC] to stop test at any time.
Note: Connected luminaires may not respond on the first action (may delay) of the master luminaire.
Movement Disable
The Movement option allows pan and tilt to be disabled so that the luminaire can be placed in any
position for testing without movement occurring. In order to regain full control of the luminaire,
Movement will need to be enabled after testing.
Note: When using the Movement option, pan and tilt will be disabled for all the luminaires that are
linked.
02.97 08.000 2
"Diagnostic Tests" on page
page 18
for more information regarding the construction of this
AC In
Data Thru
Figure 4-5: Test Setup
for a complete list of test parameters which can be chosen.
2 7 Ap ril 2 017
M
S
: S
ENU
YSTEM
64.
Luminaire 1
AC In
requiring
update
Data Thru
*DMX terminator required for last fixture on DMX line.
"Menu System Functions"
4
T
ELF
ESTS
Termination*
Luminaire 2
requiring
update
63
Advertisement
Table of Contents
Troubleshooting
