Transferring Software From Luminaire To Luminaire - Philips VARI-LITE VL6000 Beam Luminaire User Manual

❋
VARI LITE - VL6000 B
c. Once the firmware upload is complete, the VARI❋LITE luminaire(s) will automatically
Step 9. Close PEGASUS Software using Close button at bottom of program screen.
Note: You can confirm the software version in the luminaire menu.

Transferring Software From Luminaire to Luminaire

It is possible to transfer specific software versions between luminaires. As in the case of installing new
software versions, multiple luminaires can be programmed at the same time if they are data linked
together (refer to
can be updated at once.
Hardware Requirements
Data cables used in this process must have two twisted pairs and a shield. It is also recommended that
cables meet all other USITT DMX specification requirements. Refer to
A DMX termination connector is used in this process. Refer to
the construction of this connector.
AC In
Data In
Master luminaire containing
software version to download
Transfer Procedure
This procedure is used to transfer software versions between luminaires.
Step 1. At last luminaire, install DMX termination connector into DATA THRU XLR connector.
Step 2. At master luminaire (first in chain) Menu Display, press [ESC].
Step 3. Press [Up] / [Down] arrows until Fixture appears. Press [OK].
Step 4. Press [Up] / [Down] arrows until Crossload Software appears. Press [OK].
Step 5. OK? will be displayed. Press [OK] to accept.
Step 6. The status bar will show download progress.
Verify software version at luminaire:
Step 1. At Menu Display, press [ESC].
50
L U '
EAM UMINAIRE SER
recalibrate.
"Connecting Data and Power" on page
Data Thru
Figure 3-10: Software Transfer Setup
2 7 Ap ri l 2 017
M
S ANUAL
28), however a maximum of 32 luminaires
Luminaire 1
requiring
AC In
update
*DMX terminator required for last fixture on DMX line.
"Data Cables" on page
page 18 for more information regarding
AC In
Data Thru
17.
Termination*
Luminaire 2
requiring
update
02.9708.0002