Configuring Telnet For Remote Control - Siemens SIMATIC HMI KP400 Comfort Operating Instructions Manual

Commissioning the device
4.3 Parameter assignment for Comfort Panel
4.3.10.7

Configuring Telnet for remote control

When the Telnet service is activated, you can remotely control the HMI device via Telnet.
Requirement
The Control Panel is open.
Procedure
1. Open the "WinCC Internet Settings" dialog using the "WinCC Internet Settings" icon.
2. Change to the "Telnet" tab.
①
3. If you want to use the Telnet service, select the check box.
4. Confirm your entries with "OK".
The dialog closes.
5. Restart the HMI device.
The Telnet service can now be used.
128
Check box for activating the Telnet service
Operating Instructions, 07/2017, A5E36770603-AB
Comfort Panels