Parameter Assignment For Comfort Panel; Desktop And Start Center - Siemens SIMATIC HMI KP400 Comfort Operating Instructions Manual

Commissioning the device

4.3 Parameter assignment for Comfort Panel

4.3 Parameter assignment for Comfort Panel
4.3.1

Desktop and Start Center

Once the HMI device has been started, the display shows the desktop.
①
②
③
④
The Start Center
The Start Center buttons have the following function:
● Transfer – You switch the HMI device to "Transfer" mode.
The transfer is only activated if at least one data channel has been parameterized, see
section "Configuring transfer (Page 96)".
● Start – You start the project on the HMI device.
If you do not perform an operation, a project already loaded on the HMI device will start
automatically in line with the settings in the Control Panel . If no project is loaded, the
Start Center will activate the transfer.
● Settings – You start the Control Panel.
See section "Overview of functions (Page 78)".
● Taskbar – You open the task list and the Start menu.
The Start Center is displayed again if a project on the HMI device has been closed or if it is
accessed from the project.
74
Desktop
Start Center
Start menu
Icon for screen keyboard
Operating Instructions, 07/2017, A5E36770603-AB
Comfort Panels