Pioneer Elite KURO PRO 111FD Operating Instructions Manual page 21

Install Your Flat Panel TV
3 ) Hang the speaker bracket on the screw at the top by passing the wide part over it and lowering into the slot;
screw in the lower screw temporarily.
After passing the wide part of the hole of the speaker bracket (top) over the screw, lower the speaker onto it.
After passing the
wide part of the
hole over the screw,
lower the speaker.
Tighten with the provided
screw the bottom speaker
bracket to the flat panel
TV temporarily (one place
bottom).
4 ) Adjust the position of the speaker then tighten the upper and lower screws firmly.
5 ) Tighten the two screws at the top and bottom for each speaker.
6 ) Pass the supplied speaker cable between the speaker and the panel (below the speaker bracket) from below.
7 ) Connect the speaker cables to the speaker.
Refer to "
2.2.2 Connect the Speaker Cables."
(PRO-151FD)
After passing the
wide part of the
hole over the screw,
lower the speaker.
Tighten with the provided
screw the bottom speaker
bracket to the flat panel
TV temporarily (one place
bottom).
(PRO-151FD)
(PRO-111FD)
(PRO-111FD)
02
21
En