Table of Contents
Advertisement
1
AP400 GENERAL
1.1
GENERAL
This installation Manual is valid for installing a DECT transceiver (AP400) to a wall in
horizontal or vertical position. The AP400 is designed for indoor use. When installing an
AP400 outdoors, please use the dedicated Outdoor Cabinet and appropriate outdoor
cabling
Note that there are two types of DECT Transceivers:
AP400 (with internal antennas).
AP400E with directional antenna.
Note: The AP400E must always be installed/used in the outdoor cabinet! For more
information consult the manual for the Outdoor Cabinet for AP400.
Note: Please note that the AP400E is not available in USA/Canada.
1.2
COUNTRY SELECTION
Country settings are pre-determined by the DAP Controller and this ensures that the
AP400 only operates according to local country regulations. It is not possible for any 3rd
party or end user to alter these settings or download software that controls the RF
parameters.
The variant sold in each country can only operate in the frequency band allowed in that
country. This is ensured by only delivering the correct DAP controller version for each
country.
There are three types of DAP Controllers available for the AP400:
DAP Controller – International.
This version is used in EMEA countries and countries that use the European
frequencies and power levels. In these countries, only the DAP Controller -
International will be delivered, so no other frequencies than the European
frequencies and power levels are possible in this region.
DAP Controller - North America
This version is used in North America and can only use the North American
frequencies and power levels. In these countries, only the DAP Controller – North
America will be delivered, so no other frequencies than the North American
frequencies and power levels are possible in this region..
© NEC Nederland B.V. 2011
Page 12 of 34
AP400 – All Types Installation Manual
Hide quick links:
Advertisement
Table of Contents
