3
MOUNTING THE G.729 DAUGHTERBOARD
Follow the step-by-step procedure below, to install the G.729 daughter board.
PROCEDURE: "Installing the G.729 Daughter Board".
Actions
1.
Make sure that you have the G.729 Daughter board.
2.
Open the cabinet. Use steps 1 and 2 in Chapter 2.
3.
Take the PCB out of the cabinet.
Note: Mind the light conductor for the LEDs. It can drop off!
4.
Now you should have the AP400 PWB and the G.729 Daughter Board as separate
items.
5.
Remove the protection foil from the sticky part on the G.729 Daughter Board.
AP400 – All Types Installation Manual
Figure 9. Light conductor for LEDs
Page 23 of 34
LED Light conductor
© NEC Nederland B.V. 2011