Parameter Set Switchover; Parameter Set Switchover (Up To Sw 3); Axis Parameter Sets (Nck/Servo) - Siemens SINUMERIK 840C Installation Instructions Manual

12 Functional Descriptions

12.27 Parameter set switchover

12.27
The parameter set switchover function allows parameters of various NC control areas (position
control, actual value detection) or of the drive to be switched over simultaneously and with
minimum delay.
12.27.1

Axis parameter sets (NCK/SERVO)

Two parameter sets (PaSe) are available for the position control area in feed axes.
Parameter
Servo gain factor
Feed forward control factor
Time const. symm. filter
The switchover is executed implicitly when G functions for thread functions (G33, G34, G35,
G36, G63) are selected. There is no way in which the user can directly initiate the switchover
process.
Part program
Nxx G
"Thread"
2
1
SERVO
p
arameter set
Drive
parameter set
Gear stages/parameter set switchover for axes with 840 C and SW 3
12–270
More user manuals on
Parameter set switchover
The Parameter set switchover function
is as option (SW 4 and higher).

Parameter set switchover (up to SW 3)

Axis parameter
1stPaSe
2ndPaSe
MD
252* 1320*
312* 1260*
392* 1324*
NCK
axis
Actual parameter set
SERVO
axis
611D FDD
ManualsBase.com
Setpoint parameter set
DB 29, DR K+122, bit 0-2
DB 29, DR K+120, bit 0-2
Actual parameter set
© Siemens AG 1992 All Rights Reserved
10.94
PLC
6FC5197- AA50
SINUMERIK 840C (IA)