Siemens SINUMERIK 840C Installation Instructions Manual page 584

09.95
10100-
10114
10119
The "Module order code" machine data contains the selected module in the form of a decimal
code number. In the case of two-axis modules, the data contains two sets of information.
Machine data 10100 to 10114 are assigned to physical addresses 1 to 15.
10200-
10214
10229
The "Power section code" machine data contains the required or used amperages for the
selected module according to the hexadecimal code number (see also MD 1106). In the case
of two-axis modules, the data contains two sets of information. Machine data 10200 to 10214
are assigned to physical addresses 1 to 15.
10900
10901
10902
10903
10903.0
10903.1
1) As from SW 5
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
Module order code (as from SW 4)
1)
Default value Lower output limit
0
Power section code (as from SW 4)
1)
Default value Lower output limit
0000 0000
Data version (as from SW 4)
Default value Lower output limit
–
Firmware version (as from SW 4)
Default value Lower output limit
–
Firmware data (as from SW 4)
Default value Lower output limit
–
Hardware configuration (as from SW 4)
Default value Lower output limit
–
Mixed I/O
DCM
ManualsBase.com
7 Drive Machine Data (SIMODRIVE Drive MD)
7.4.3 Diagnosis/service MD (data description - as from SW 3)
Upper output limit
0 65535
Upper output limit
FFFF
Upper output limit
– –
Upper output limit
– –
Upper output limit
– –
Upper output limit
– –
6FC5197- AA50
Active on
Power on
Units
-
Active on
Power on
Units
Hex
Active
Units
–
Active
Units
–
Active
Units
–
Active
Units
–
7–169