Siemens SINUMERIK 840C Installation Instructions Manual page 414

01.99
Axis converter setting data
SD
626*
to
699*
The setting data are stored in binary format as follows.
SD 626*
SD 630*
Setting data software cam
SD
7000
to
7007
The cam positions refer to machine zero and are used in the active machine dimension
system (metric or inch). No check is made that the set cam position is within the maximum
positional values (maximum traversing range).
The setting data for the cam positions can be read or written using the @ functions.
The setting data are stored in binary format as follows:
SD 7000* Minus cam of cam pair 1
SD 7001* Plus cam of cam pair 1
SD 7004* Minus cam of cam pair 3
SD 7005* Plus cam of cam pair 3
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
7 6
1st programmed axis channel-
specific
2nd programmed axis channel-
.
specific
.
.
7 6
ManualsBase.com
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
Bit No.
5 4 3
Axis converter
SD 628* 1st machine axis channel-
specific
SD 632* 2nd machine axis channel-
.
specific
.
.
Bit No.
5 4 3
Software cams
SD 7002* Minus cam of cam pair 2
SD 7003* Plus cam of cam pair 2
SD 7006* Minus cam of cam pair 4
SD 7007* Plus cam of cam pair 4
6FC5197- AA50
6.12.1 NC setting data (NC SD)
2 1 0
2 1 0
6–229