Siemens SINUMERIK 840C Installation Instructions Manual page 77

4 MMC Area Diagnosis
4.3 Drive service displays for spindle (MSD) and axis (FDD) – as from SW 3)
Message ZK1
Pulse enable actual
DC link
Actual parameter set
Actual motor selection
Position actual value
Speed actual value
Speed setpoint
Capacity utilization
Active power (SW 4)
Smoothed current
actual value (SW 4)
Motor temperature
Status of binary
inputs (SW 3)
Display of active
functions 1 (SW 3)
Display of active
functions 2 (SW 3)
4–14
More user manuals on
This display field contains the state of message state class 1 of cyclic status
word 1 (drive MD 11002.0).
Possible display range: off or on.
This display field contains the state of enabled pulses of cyclic status word 2
(drive MD 11003.7).
Possible display range: off or on
This display field contains the status of the DC link (drive MD 11006.0).
Possible display range: off or on
This display field contains the current actual parameter set of cyclic status word 2
(drive MD 11003.0–2).
Possible display range: 0 – 7
This display field contains the actual motor type of cyclic status word 2 (drive MD
11003.3).
Possible display range: Y or D (8 star or delta)
This display field contains the current positional actual value (SW 4: drive MD
12000). It is dependent on the position control of the rotary axis (NC MD 5640.5)
and position control resolution (NC MD 18000.0–3).
This display field contains the current speed actual value of the motor (SW 3:
drive MD 2/SW 4: drive MD 1707).
This display field contains the current speed setpoint of the motor (SW 3: drive
MD 1/SW 4: drive MD 1706).
This display field shows the capacity utilization of the main spindle drive. Up to
the rated speed, the ratio of torque to maximum torque is displayed, and above
the rated speed the ratio of power to maximum power is displayed
(SW 3: drive MD 4/SW 4: drive MD 1722).
This display field shows the current active power (drive MD 11011).
This display field shows the smoothed current actual value in percent
(drive MD 1708).
This display field shows the current motor temperature
(SW 3: drive MD 10/SW 4: drive MD 1702).
This display field contains the state of the binary input (drive MD 11).
Possible display range: 0000 – FFFF
This display field contains the current status of active functions 1
(drive MD 254).
Possible display range: 0000 – FFFF
This display field contains the current status of active functions 2
(drive MD 255).
Possible display range: 0000 – FFFF
ManualsBase.com

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
SINUMERIK 840C (IA)