Siemens SINUMERIK 840C Installation Instructions Manual page 364

01.99
1708*-
1732*
These MD have the same meaning as MD 1432*, see also "Functional Descriptions:
Parameter set switchover".These machine data are only active with gearbox interpolation.
1736*-
1764*
Meaning: Limitation of max. velocity for following axis. These machine data are only active with
gearbox interpolation.
Note:
For parameter grouping see under "Functional Descriptions: Parameter set switchover".
1768*-
1796*
Meaning: Limitation of max. acceleration for following axis. These machine data are only active
with gearbox interpolation.
Note:
For parameter grouping see under "Functional descriptions: Parameter set switchover".
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
Time constant parallel model 2nd - 8th parameter set
Default value Lower input limit
6 000
Alarm limit velocity 1st - 8th parameter set
Default value Lower input limit
11 000
Alarm limit acceleration 1st - 8th parameter set
Default value Lower input limit
55
ManualsBase.com
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
(as from SW 4)
Upper input limit
0 16 000
(as from SW 4)
Upper input limit
1 99 999 999
(as from SW 4)
Upper input limit
0 16 000
6FC5197- AA50
6.7 Axis-specific MD 2 (axial data 2)
Active on
RESET
Units
0.01 ms
Active on
NC Stop
Units
10 000 units/s 2
Active on
NC Stop
Units
2
10 000 units/s
6–179