Siemens SINUMERIK 840C Installation Instructions Manual page 590

10.94
11009
This machine data specifies the capacity utilization of the digital drive as a percentage
(0 ... 7FFF H ˆ = 0 ... 100%).
11010
This machine data specifies the torque setpoint of the digital drive as a percentage
(-32768 ... 32767 ˆ = -200% ... 200%). The torque corresponding to 100 % (internal notation
4000 H) is stored in machine data "Scaling torque setpoint interface" (MD 1725).
11011
This machine data specifies the active power of the digital drive.
11012
This machine data specifies the current actual value of the digital drive as a percentage
(-32768 ... 32767 ˆ = -200% ... 200%). The limit current corresponding to 100 % (internal
notation 4000 H) is stored in the machine data "Transistor limit current power section" (MD
1107).
11013
This machine data specifies the current actual value of the digital drive. The actual speed
value corresponding to 100 % (internal notation 4000 H) is stored in the machine data "Speed
for max. motor operational speed" (MD 1401).
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
Capacity utilization (as from SW 4)
Default value Lower output limit
– 0000
Torque setpoint (as from SW 4)
Default value Lower output limit
– -32 768
Active power (as from SW 4)
Default value Lower output limit
– -327.68
Current actual value (as from SW 4)
Default value Lower output limit
– -32 768
Speed actual value (as from SW 4)
Default value Lower output limit
–
ManualsBase.com
7 Drive Machine Data (SIMODRIVE Drive MD)
7.4.3 Diagnosis/service MD (data description - as from SW 3)
Upper output limit
7FFF
Upper output limit
32 767
Upper output limit
327.67
Upper output limit
32 767
Upper output limit
-200 200
6FC5197- AA50
Active
at once
Units
Hex
Active
at once
Units
–
Active
at once
Units
kW
Active
at once
Units
–
Active
at once
Units
%
7–175