Yamaha FJR13AEV(C) Service Manual page 36

Odometer and tripmeter modes
1. Odometer/tripmeter/fuel reserve tripmeter
2. "SELECT" button
3. "RESET" button
Pushing the "SELECT" button switches the dis-
play between the odometer mode "ODO" and
the tripmeter modes "TRIP 1" and "TRIP 2" in the
following order:
ODO → TRIP 1 → TRIP 2 → ODO
NOTE:
When selecting "TRIP 1" or "TRIP 2", the display
flashes for five seconds.
When approximately 5.5 L (1.45 US gal) (1.21
Imp.gal) of fuel remains in the fuel tank, the dis-
play will automatically change to the fuel reserve
tripmeter mode "F-TRIP" and start counting the
distance traveled from that point. In that case,
pushing the "SELECT" button switches the dis-
play between the various tripmeter and odome-
ter modes in the following order:
F-TRIP → TRIP 1 → TRIP 2 → ODO → F-TRIP
To reset a tripmeter, select it by pushing the "SE-
LECT" button, and then push the "SELECT" but-
ton for at least one second while the display is
flashing. If you do not reset the fuel reserve trip-
meter manually, it will reset itself automatically
and the display will return to the prior mode after
refueling and traveling 5 km (3 mi).
Clock
1. Clock
2. "SELECT" button
3. "RESET" button
To set the clock:
1. Push the "SELECT" button and "RESET" but-
ton together for at least two seconds.
2. When the hour digits start flashing, push the
"RESET" button to set the hours.
3. Push the "SELECT" button, and the minute
digits will start flashing.
4. Push the "RESET" button to set the minutes.
5. Push the "SELECT" button and then release
it to start the clock.
Fuel meter
1. Fuel meter
The fuel meter indicates the amount of fuel in the
fuel tank. The display segments of the fuel meter
disappear towards "E" (Empty) as the fuel level
decreases. When the last segment starts flash-
ing, refuel as soon as possible. When the key is
turned to "ON", all of the display segments of the
fuel meter will appear one after the other and
then disappear in order to test the electrical cir-
cuit.
NOTE:
This fuel meter is equipped with a self-diagnosis
system. If the electrical circuit is defective, all the
display segments will start flashing. If this oc-
curs, check the electrical circuit.
Refer to "SIGNALING SYSTEM" on page 8-39.
1-27
FEATURES