Program Control - Siemens SINUMERIK 828D Manual

CNC operation in automatic mode (AUTO)

8.2 Program control

8.2 Program control
You can influence the program sequence in the AUTO and MDI modes. The following
options are available to do this:
PRT – no axis motion
The program is completely executed with the axes stationary, e.g. for the program test.
DRY – dry run feedrate
The traversing velocities programmed in conjunction with G1, G2, G3, CIP and CT are
replaced by a defined dry run feedrate.
RG0 – reduced rapid traverse
You define the reduced rapid traverse in the settings for automatic operation.
M01 – programmed stop 1
The processing of the program stops at every block in which supplementary function M01
is programmed. In this way you can check the intermediate result
when machining a workpiece.
DRF – handwheel offset
This selection allows you to enter an additional incremental work offset while processing
in automatic mode with an electronic handwheel.
SKP
Skip blocks are skipped during machining.
MRD
The display of the measurement result can be enabled or disabled during program
execution.
Benefits
Secure positioning of new part programs
Continue machining quickly after interruptions
50
SINUMERIK 828D
BASIC
Basic configuration
SINUMERIK 840D sl
BASIC
Basic configuration
Control system overview for machine tools' sales people, 2017, A5E41992599B AA
SINUMERIK 828D
Basic configuration
SINUMERIK 840D sl
Basic configuration
SINUMERIK 828D
ADVANCED
Basic configuration
SINUMERIK Operate - Milling