Dell Edge Gateway 3003 Installation And Operation Manual page 52

• <ssidname> = iotisvlab, where ssid is the name of the access point.
• <name> = testwifi, where name is the connection name, which is basically a connection identifier.
• <keytype> = wpa-psk, where keytype is the WLAN key management security type being used.
• <passco> = happy, where passco is the WLAN passcode or password for the access point.
Enter the following at the command prompt to view the network interfaces.
$ network-manager.nmcli d
Enter the following at the command prompt to find a list of available access points.
$ network-manager.nmcli d wifi
Run the following commands and replace $SSID, $PSK, and $WIFI_INTERFACE of your environment.
• Connect
$ sudo network-manager.nmcli dev wifi connect $SSID password $PSK ifname $WIFI_INTERFACE
OR
$ sudo network-manager.nmcli dev wifi connect $SSID password $PSK
• Disconnect
$ sudo network-manager.nmcli dev disconnect $WIFI_INTERFACE
Enter the following at the command prompt to add a connection to the system.
$>: network-manager.nmcli con add con-name <name> ifname wlan0 type wifi ssid <ssidname>
For example:
$>: network-manager.nmcli con add con-name testwifi ifname wlan0 type wifi ssid iotisvlab
Enter the following at the command prompt to provide the system with the passkey that is used on the access point.
$>: network-manager.nmcli con modify <name> wifi-sec.key-mgmt <keytype>
For example:
$>: network-manager.nmcli con modify testwifi wifi-sec.key-mgmt wpa-psk
Enter the following at the command prompt to provide the system with the passcode for the access point.
$>: network-manager.nmcli con modify <name> wifi-sec.psk <passco>
For example:
$>: network-manager.nmcli con modify testwifi wifi-sec.psk happy
Enter the following at the command prompt to bring up the connection (allows the system to connect to the access point and get an IP
address).
$>: network-manager.nmcli con up id <name>
For example:
$>: network-manager.nmcli con up id testwifi
Bluetooth
Run the following commands to pair Bluetooth devices such as a Bluetooth keyboard:
1. Start the bluetoothctl console.
#bluez.bluetoothctl -a
2. Turn on the device.
$ power on
3. Register the agent for keyboard.
$ agent KeyboardOnly
$ default-agent
4. Put the controller in pairable mode.
$ pairable on
5. Scan for nearby Bluetooth devices.
$ scan on
52