Huawei DBS3900 Installation Manual page 99

LampSite
Installation Guide
NE
l In the label, RHUB3908 and pRRU3901 identify the specific LampSite NEs.
l If only one RHUB3908 is deployed, mark it as RHUB39080 on the label. If multiple RHUB3908s are
l If only one pRRU3901 is deployed, mark it as pRRU39010 on the label. If multiple pRRU3901s are
l For details about the maximum number of RHUB3908s and pRRU3901s in the LampSite solution, see
Label Structure
Using the RHUB3908 power label as an example,
engineering label.
Issue 08 (2015-01-15)
Label Content
Network
transmissi
on label
Antenna
label
NOTE
deployed, mark them in ascending sequence, beginning with RHUB39080.
deployed, mark them in ascending sequence, beginning with pRRU39010.
Typical Configurations in LampSite Technical Description.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
pRRU390 Label for the pRRU3901y
1y Ethernet cable.
CPRI_Ea l y specifies the number of
pRRU3901s and cannot
exceed the maximum
pRRU3901 number
supported by the
networking.
l a can be set to 0 to 7,
which respectively
correspond to CPRI_E0
port to CPRI_E7 port of
the RHUB3908.
pRRU390 Label for the pRRU3901y
1y RF Jumper.
ANTa l y specifies the number of
pRRU3901s and cannot
exceed the maximum
pRRU3901 number
supported by the
networking.
l a can be set to 0 to 5,
which respectively
correspond to ANT0
port and ANT5 port of
the pRRU3901.
Figure 8-1
8 Appendix
Corresponding
port on the base
station
CPRI_E0 or
CPRI_E1
ANT0 to ANT5
shows the structure of a LampSite
94