Table of Contents
Advertisement
f.
Separate the connector to the 00 track sensor.
g.
Remove the heat-shrinkable tubing and unsolder the
connections of the media-in sensor, the write pro
tect sensor, and the optical tachometer sensor.
h.
Separate
frame by spreading the clips that fasten the sensor
cable to the base frame.
i.
Remove the sensor cable assembly from the base frame
with the LED assembly and index sensor attached.
Use the following procedure to install and adjust the index
sensor.
a.
Insert the index sensor into the index sensor groove
in the base frame.
b.
Install
base frame but do not tighten it.
c.
Insert the index sensor adjusting pin into the hole
in the index sensor.
d.
Push
the
touches
(see Figure 4-12).
e.
Tighten the screw that fastens the index sensor to
the base frame.
Figure 4-12
the sensor
cable assembly
the screw that fastens the sensor
index
sensor
the
adjusting
surface
Do not remove the adjusting pin.
Installing the Index Sensor
4-13
from the base
so that
the adjusting pin
of
the
to the
base
frame
Advertisement
Table of Contents
