Table of Contents
Advertisement
Use the following procedure to replace the pop-up assembly.
a.
Install
being careful not to damage the picker rod.
b.
Check
Section 4.4.15).
4.4.14
Guide Rail Removal
Use the following procedure to remove the guide rail.
a.
Remove the lever plate by removing the four screws
that secure it to the lever plate hinges.
b.
Remove the two screws that fasten the guide rail to
the frame (see Figure 4-18).
c.
Remove the guide rail.
Figure 4-18
4.4.15
Checking the Operation of the Pop-Up Feature
After replacing the picker rod or the pop-up assembly, check
the operation of the pop-up feature as follows.
a.
Turn on the power supply for the disk drive.
b.
Insert
pop-up feature locks in place.
c.
Close the door of the disk drive.
the
pop-up
the
operation
Removing the Pop-Up Assembly and Guide Rail
the flexible disk and make
assembly
into
of
the
pop-up
4-19
the
base-frame,
assembly
(see
sure
that
the
Advertisement
Table of Contents
