Table of Contents
Advertisement
c.
Pick
up the magnet cap slowly and evenly
highly magnetized).
d.
If
the
screws
motor flange, loosen screw C, and move the flange
toward the front of the disk drive to take pressure
off of the carbon brushes.
e.
Remove the spindle screw
lift the armature up to remove it.
4.4.10
Spindle Assembly Removal
Use the following procedure to remove the spindle assembly.
a.
Remove the armature.
b.
Remove the optical tachometer sensor.
c.
Turn the spindle until the two holes in the spindle
line
up with
assembly to the base frame.
d.
Remove the two screws (see Figure 4-15) and lift the
spindle assembly out of the base frame.
Figure 4-15
carbon
brushes
A
and B
(see Figure
the
screws that fasten
Removing the Spindle Assembly
4-16
are
installed,
4-14)
that
(left-handed thread)
(it is
remove
the
hold
the
and
the spindle
Advertisement
Table of Contents
