Outgoing Call Lock; Restrict Call Mode Setting - LG LST-270T User Manual

Programming

5.6 Outgoing Call Lock

If you try to make an outgoing call while outgoing call
lock is enabled, then you will hear warning tone after
dial time-out as an indication of entering the LOCK
code. You should enter LOCK code to make an
outgoing call. LOCK code is composed of 4 digits.
Outgoing Call Lock feature is disabled as a factory
setting.
Enable or Disable Outgoing Call Lock
1. Press "#"+ "#"+ "6" + continuously to enter
Outgoing Call Lock programming mode.
2. Press "#" and "LOCK code (4 digits)".
3. Press "#" and Enable ("1") or Disable ("2")
code.
4. Press "*" to save.
Changing Outgoing LOCK Code
1. Press "#" + "#" + "6" + continuously to enter
Outgoing Call Lock programming mode
2. Press "#" and "LOCK code (4 digits)"
26
3. Press "#" and "3" to change LOCK code.
4. Press "#" and "new LOCK code (4 digits)".
5. Press "#" and re-enter "new LOCK code (4
digits)".
6. Press "*" to save.
Note :
- If Emergency Call has been enabled, then Emergency
Call Numbers stored can be made even when
Outgoing Call Lock has been activated on the
terminal.

5.7 Restrict Call Mode Setting

While the Restrict Call function is enabled, the
specified numbers cannot be called. These specified
numbers start with specific digits. The specific digits
are set according to the following procedure (Storing
the Deny dial number).
Among these specified numbers you can permit some
numbers by designating start digits by following
procedure (Storing the Permit dial number).
LST-270T has 10 Deny dial numbers (1~10), and
max. 32 digits can be stored in each Deny dial
number.
LST-270T has 10 Permit dial numbers (1~10), and
max. 32 digits can be stored in each Permit dial
number.
If you set Emergency Call, the emergency number is
not applied to this restrict call.
Set Restrict Call Level
1. Press "#"+ "#"+ "8"+ continuously to enter
Restrict Call programming mode.
2. Press "#" and "LOCK code"
(4 digits : set in Outgoing call lock / default is
0000).
3. Press "#" and restrict level (1~4).
"1" - No restriction
"2" - Restriction
"3" - Emergency only (All excepting emergency are
restricted.)
Programming
"4" - Clear restrict table
4. Press "*" to save.
Storing the Permit Dial Number
1. Press "#"+ "#"+ "8"+ continuously to enter
Restrict Call programming mode.
2. Press "#" and "LOCK code".
(4 digits : set in Outgoing call lock / default is
0000).
3. Press "#" and "1" to enter Permit Dial Number
store step.
4. Press "#" and one of "Memory number" for
permit dial number(1~10).
5. Press "#" and the °∞digits°± (Max. 32digits).
6. If you want to store more Permit Dial Numbers
continue from step 3.
If you want to finish at this point, Press "*" to
save.
27