Table of Contents
Advertisement
Introduction
2.2 Front, Side and Rear View of the Terminal
I I T T E E M M
(1) LEDs
(2) DC IN 12V
(3) Battery Switch
(4) TEL (RJ-11 Port)
(5) DATA Port (RJ-45 Port)
(6) Antenna Connector
(7) Power
10
< Figure 1 >
D D E E S S C C R R I I P P T T I I O O N N
Indicate the status of the unit
AC/DC Power Adapter
Battery On/Off Switch
Connecting Ports for SLT
(Single Line Telephone)
Connecting Port for Repair(RS-232C)
Connecting Port for TNC Antenna
Power On/Off Key
< Mounting Template >
Installation for Wall Mounting
▶
To mount terminal on the wall, please follow the
procedure to install it correctly.
1. Determine suitable location to mount terminal
with mounting template.
2. Mark the two openings and select round or pan-
head type screw.
3. Drill out the holes with drill bit smaller in
diameter than the screws.
Introduction
4. Secure two screws into the wall, leaving about
65mm gap between the screw heads.
5. Insert the DC power jack into an electrical outlet
and attach the telephone line into the Phone
Jack (RJ-11) of the terminal.
6. Place the terminal over the two screws.
7. Slide the terminal downward until the screw head
is locked at the top of the opening and the
terminal is secure.
8. Check that set is fixed on the screws.
11
Advertisement
Table of Contents
